Trim/Tilt Pin Wrench AMT0006-32mm x 4.5/4mm Remove Trim/Tilt Caps on Hydraulic Cylinders for Yamaha, Suzuki, Johnson, Evinrude, Honda Outboards

🚤Fits for all SHOWA manufactured Trim/Tilt Units on Yamaha, Evinrude, Johnson, and Suzuki Outboards.🚤Made of hardened stainless steel coated with silver finish for extended longevity and durability,Direct replace OEM# YB-06175-1A Replaceable Hardened Stainless Steel Pins with Gripping Teeth for added security,1/2" Socket Drive - 46m-lb Torque Rating,180 ft-lb MIN Pin Strength.🚤Remove the trim/tilt caps, trim seals on hydraulic cylinders without damaging. Replaceable hardened stainless steel pins with gripping teeth which properly against the cap, so never worry broken your pin again.🚤To rebuild a leaked device on outboard engine, hydraulic trim and tilt unit .Used to remove and install the Trim and Tilt Caps without damaging it and the steering cylinder.Usually, you will put a little drift into one of those holes in the trim and tilt caps with a hammer. Than,you destroy these cap ,you will thrown them away,which cost a about hundred bucks. So, you really need the pin wrench to help you finish that case with ease.At EnRand, we serious to offer the best products and services to customers. Provide friendly ,easy-to-reach support. Any question you have, please contact EnRand Support Team. We will get you back within 24 hours.

• 🚤Fits for all SHOWA manufactured Trim/Tilt Units on Yamaha, Evinrude, Johnson, and Suzuki Outboards.✅
• 🚤Made of hardened stainless steel coated with silver finish for extended longevity and durability,Direct replace OEM# YB-06175-1A Replaceable Hardened Stainless Steel Pins with Gripping Teeth for added security,1/2" Socket Drive - 46m-lb Torque Rating,180 ft-lb MIN Pin Strength.✅
• 🚤Remove the trim/tilt caps, trim seals on hydraulic cylinders without damaging. Replaceable hardened stainless steel pins with gripping teeth which properly against the cap, so never worry broken your pin again.✅
• 🚤To rebuild a leaked device on outboard engine, hydraulic trim and tilt unit .Used to remove and install the Trim and Tilt Caps without damaging it and the steering cylinder.Usually, you will put a little drift into one of those holes in the trim and tilt caps with a hammer. Than,you destroy these cap ,you will thrown them away,which cost a about hundred bucks. So, you really need the pin wrench to help you finish that case with ease.✅