TEMO 10 pc 1/4 Inch Rubber Mandrel Sand Drum Holder 1/8 Inch Shank for Dremel Rotary Tools...

TEMO 10 pc 1/4 Inch Rubber Mandrel Sand Drum Holder 1/8 Inch Shank for Dremel Rotary Tools
10 pc 1/4" (6.35mm) Rubber Mandrel 1/8” inch Shank Sand Drum Holder for Dremel Rotary tool
10 piece 1/4" (6.35mm) X 1/2" (12.7mm) Rubber Mandrels; used to hold 1/4" (6.35mm) diameter sand drum or sand band; 1/8" (3.175mm) shank size for Dremel and other Rotary Tools
Here are our best practices for using sand drums. 1. Adjusting the screw at the top of the mandrel will loosen or tighten the sand drum. Make sure the sand drum is held tight to the mandrel before use. 2. During use, periodically power down the rotary tool to check the sand drum. Ensure that there is sufficient grit remaining on the band before continuing.
3. Rotary tools can operate at very high RPM. High RPM with a small tool such as a sanding drum produces a lot of friction and heat build up. Ensure that your sand drum and mandrel is not getting too hot. Consider using medium speed and alternating mandrels as you change sand drums out to reduce heat build up.
4. Rotary tools are power tools. Always consider appropriate eyewear and other PPE to suit your task.
US-BASED CUSTOMER SERVICE: Available by chat, email, phone, or visit us at our customer service center in La Crosse, WI.



3 x 3 x 0.3 inches

Return

Payment

Feedback

Contact Us