Solderless DIY Custom Guitar Pedal Cable Kit 6 Pack with Right Angle Low Profile Connectors for Pedalboard (Orange Cable Kit)

Kurrent Electric Solderless Instrument / Guitar Pedal Patch Cable Kit 6 Pack For Custom Pedalboard These can quickly and easily be used to make a custom length right angle 1/4" patch cable. Is your pedalboard a mess? Add a loop selector and need more patch cables now and those precut cables aren't reaching where you need them? This is a great solution to tidy up your pedal board. With compact right angle connectors, you can maximize that precious real estate on your pedalboard. They're perfect for pedal loop switchers that have the inputs and outputs so close together. You customize the length of each cable to the length you need it to be. No soldering required. All tools and instructions needed are supplied in each kit. Lifetime warranty. Message us through eBay with any warranty issues, we are happy to offer support. Kit includes: (6 pairs) Solderless 1/4" Mono Plugs. (12) Feet of high-quality coaxial instrument cable (1) Small Phillips Screwdriver (1) Cable cutter (1) Instruction sheet Measure and cut the cable to the desired length. Do your best to cut the cable off clean and flush. Do not strip the jacket, just cut the cable flush. Take one of the right angle connectors and back out the set screw far enough to make room to slide the cable in. (Try not to back out the screw so far that it falls out and gets lost. I've found it helpful to assemble these over an area where the screw will be easily found if you drop it.) Gently slide the end of the cable into the connector all the way in until it stops. Hold things together as you gently twist in the set screw. This screw will secure the cable into the plug as well as piercing the jacket in order to ground the connection. Repeat for the required number of patch cables. It's highly suggested to test each cable individually after assembly to ensure you have a good connection. If necessary it's easy to disassemble and try again. Troubleshooting: We recommend testing each cable after assembly. If the signal seems weak, no worries, just disassemble and try again. It's probably best to try with a fresh cut of cable. Just snip off a bit of the cable, reassemble and test it again. :)

• (6 pairs) Solderless 1/4" Mono Plugs (enough to make 6 cables)
• (12) feet of high-quality coaxial shielded instrument cable
• (1) Small Phillips Screwdriver
• (1) Cable cutter
• (1) Instruction sheet
• Compact, low profile
• Easy Solderless Assembly. You can assemble C shape and S shape cables of various lengths as needed.