Skimmer Door Weir Flap 8-3/8" For Hayward SP1070 Swimquip U3 For SPX1070KHR

Inland Pool And Spa Aftermarket Replacement 8-3/8" skimmer weir door for the SwimQuip U3, Hayward SP1070 (SPX1070KHR). Installation of weir: Installing weir doors is easy and take a few minutes: Turn off the pump and filter. With no water movement, this makes it easier to move around the skimmer. Remove the skimmer lid. We want to install the door by reaching into the skimmer from the top. Insert the spring-loaded weir door at the lower bottom position of the skimmer where the tile meets skimmer throat. Make sure that the flat side of the weir is facing upwards and the foam float is facing downwards towards the basket. Align the weir prior to pulling the pin release handle. This will release the pins so that they stick on the walls. You may need to reposition the weir slightly so that when is swivels upwards it touches the bumper stop built into the skimmers upper throat. Make any adjustment prior to turning pump on. . Turn the pump and filter back on and check water flow into the skimmer. When the pump shuts off the weir door should close and keep debris inside the skimmers basket area and preventing it from entering back into the pool.

• Inland Pool And Spa Supply Aftermarket Replacement 8-3/8" skimmer weir door with spring-loaded design for use with the SwimQuip U3, Hayward SP1070 (SPX1070KHR). Replacement For Hayward Sp1070 Skimmer and Swimquip U3 Skimmer.
• Inland Pool And Spa Supply Aftermarket White 8-3/8" Pool Skimmer Weir Door with spring-loaded design compatible replacement for part numbers: SPX1070KHR and R240067
• Measurements: 8-3/8" Length, x 1-1/8" wide, X 5-1/4 Inch Height (see photo for size details)
• Color: White