PWM to Voltage PWM to 0-5v 0-10v Low Frequency 5~500Hz Linear Conversion Transmitter Module

PWM to voltage module This is a linear conversion module, which outputs PWM data through internal chip processing and expressed by voltage signal. Module parameters 1. Power supply voltage: 9V~24V 2. Signal input voltage range: 4~24V 3. Signal input frequency range: 5Hz ～ 500Hz 4. Signal input duty cycle range: 0~100% 5. Output voltage: 0.00V-5.00V/0.00V-10.00V 6. Input mode: J1 pad on the circuit board: open circuit by default, not used yet 7. Output mode: J2 pad on the circuit board: open circuit (output 0.00V~5.00V); Short circuit (output 0.00V~10.00V), default is open circuit 8. Scope of application: remote data acquisition and control equipment 9. Size: (L) 26mm * (W) 23mm * (H) 10mm 10. Module interface: 24V: power supply positive interface (9V~24V) G: Power ground interface IN: signal input positive interface G: Signal input negative interface OUT: signal output interface (0.00V ～ 5.00V/0.00V ～ 10.00V) G: Power ground interface Note: When 0.00V~10.00V is output, the power supply voltage shall be 15V Output (0.00V ～ 5.00V) resolution: 0.050V/D (V/duty cycle) Output (0.00V ～ 10.00V) resolution: 0.100V/D (V/duty cycle) Formula for calculating the measured duty cycle: (output voltage (V)/resolution)=duty cycle (%) For example, the output (0.00V~5.00V) is 2.5V (2.5(V)/0.05) = 50(%)。

• Power supply voltage: 9V~24V
• Signal input voltage range: 4~24V
• Signal input frequency range: 5Hz ～ 500Hz
• Size: (L) 26mm * (W) 23mm * (H) 10mm
• power supply positive interface (9V~24V)