PM-002/MT2 Pen Mandrel Kit with 5pc Bush, 7mm Drill Bit and Mandrel Saver, MT2 for woodturning.MT2 Pen Press Kit For Woodturning Lathes with 2MT Taper.

PM-002/MT2 Pen Mandrel Kit with 5pc Bush, 7mm Drill Bit and Mandrel Saver, MT2 for woodturning.MT2 Pen Press Kit For Woodturning Lathes with 2MT Taper.

• This Pen Mandrel Kit has all you need to start turning your own pens. Includes a 7mm drill bit, mandrel, and live mandrel saver. The live mandrel saver allows you to attached your pen mandrel to your tailstock without over-tightening or under-tightening.
• The pen mandrel slides through the center bore in the live center nose, so mounting adjustments are fast and super secure. The shaft is made by hardened stainless steel for durability and smooth operation.
• A perfect kit to eliminate damaged mandrels and out-of-round pen blanks by putting pressure directly on the pen bushing, not the mandrel.
• This simple Pen Press is designed to be used in conjunction with your lathe. There are two nylon pads, the white one has a small dimple in the centre to hold the nib in line. The black pad has a concave dome cut into it to make sure the other end of the pen is also held central and stops it from slipping out. Both pads come supplied on a 2 morse taper shaft.
• To use the pen press. Put the white pad into the headstock taper and the black pad into the tailstock, insert the nib into the white pad and slide the tails stock in until the black pad is pressed against the other end and lock off. Simply wind the tailstock shaft forward which will press the pen parts together. Once the parts are pressed together unwind the tailstock and remove the pen.