Outdoor Umbrella Heater/Patio Heater Replacement Flameout Protection Device Thermocouple Wire Sensor (Dump Switch Connections) stability

Operation Instructions :1). install the thermocouple tip on a board and use two nuts to fix it's location2). Keep the tip at around 5mm distance from the burner hole in right height.3). Faston the thermocouple nut M8 on the valve end tightly (Check if your valve end thread if 8mm before you buy)4). Connect two flat terminals well with the current tilt switch terminals.5). Open gas and push your valve around 5-10s till the thermocouple head is heated enough.6). Release your hand and it work properlyIf when you release hand, gas valve shut off again, Please checka. If your thermocouple is always be heated on flameb. If the thermocouple end is well connect with valvec. If the terminals connect tilt switch well.Model Number : AI-RDO001AEasy to use,Easy to replacesturdy and durable,and long service life.

• End Nuts for gas valve 8mm, Two Flat square terminals width 4.8 mm for tilt switch
• Extend total length 350mm for patio heater
• Thermocouple head is common groove type fixed by clips
• High temperature resistance protection sleeve
• Terminal connect anti-down switch
• Professional manufacture, delicate and delicate, compact structure.