Oetiker 15100009 Stainless Steel Hose Clamp, Double Ear, Clamp ID Range 15 mm (Closed) - 18 mm (Open) (Pack of 100)

Genuine Oetiker 2-Ear Clamps The ears of these clamps do not have a dimple and nearly double the clamping range, compared to the 1-ear clamp. 2 ears provide a degree of elasticity to accommodate changes in size of the parts being joined, such as that which may be caused by thermal expansion or vibration. Clamp diameter The following applies as a guideline: To determine the correct clamp diameter, push the hose onto the attaching material, (e.g. the nipple), and then measure the outer diameter of the hose. The value of the outer diameter must be slightly above the average value of the diameter range of the clamp to be selected. The listed size of the clamp denotes the inner diameter (id) of the clamp. How to Install These clamps can be easily installed using Oetiker Hand Installation Pincers (HIP). The HIP tools have been designed especially for pinching ear clamps quickly and easily. Oetiker HIP Compound Action, Standard Jaw Pincer, Item No. 14100386 Oetiker HIP Compound Action Side Jaw Pincer, Item No. 14100387 Oetiker HIP Single Action Standard Jaw Pincer, Item No. 14100396 How to Remove Ear clamps can be easily removed using Oetiker’s hand clamp cutter (HCC). The HCC tool is designed to safely remove ear clamps. Oetiker Hand Clamp Cutter, Item No. 14100407 Please Note: The clamps included in this kit are not designed or intended for use in PEX applications. The sizing references for PEX clamps are not the same as standard Oetiker clamps. Oetiker PEX Clamps should be used for PEX applications.

• Two ears for nearly double the clamping range of one-ear clamps
• Applies uniform force for secure clamping
• Two-ear clamps accommodate thermal and vibrational expansion for a surer hold than other clamp types
• Stainless steel for resisting scaling and corrosion