MECCANIXITY Carbon Brush Holder Cap Motor Electric Brush Plastic Cover Thread Black 12mm/0.47 Inch OD Pack of 8

What is this?Round black carbon brush cap, used as a cover for installing carbon brushes in power tools, is suitable for most motors. Suitable for hammer, electric saw, electric grinder, trimming machine, etc.What will I get?Pack of 8 Carbon Brush Caps; Outer Diameter: 12mm/0.47 Inch ; Material: Plastic.Are there any advantages of the product?The cap is made of black durable plastic for the carbon brush holder with long service life. It is a good substitute for the old carbon brush cap.How to use it?After removing the carbon brush holder, remove the caps, replace the brush caps you received.What should I notice?Tips: When installing the carbon brush and the cap, make sure that the square back cap of the brush holder is pressed against the power contact piece and then fastened. The outer diameter of the cover must match the hole diameter of the position where the carbon brush is installed. Please pay attention to the size before ordering.

• Round black carbon brush cap, used as a cover for installing carbon brushes in power tools, is suitable for most motors. Suitable for hammer, electric saw, electric grinder, trimming machine, etc.
• Pack of 8 Carbon Brush Caps; Outer Diameter: 12mm/0.47 Inch ; Material: Plastic.
• The cap is made of black durable plastic for the carbon brush holder. It is a good substitute for the old carbon brush cap. It has good heat and wear resistance, good corrosion resistance, good sealing performance, waterproof and dustproof, smooth surface and accurate thread, which can match the machine accurately.
• After removing the carbon brush holder, remove the caps, replace the brush caps you received. Measure the old cap with a caliper, if the measured cap diameter is about 11.5mm, it is recommended to order a 12mm carbon brush cap.
• Tips: When installing the carbon brush and the cap, make sure that the square back cap of the brush holder is pressed against the power contact piece and then fastened. The outer diameter of the cover must match the hole diameter of the position where the carbon brush is installed. Please pay attention to the size before ordering.