Little Giant 6-CBA 115-Volt, 1/3 HP, 2760 GPH, Automatic Submersible Epoxy Impregnated Cast Bronze Sump Pump for Salty/Briny Water Conditions with Integral Diaphragm Switch, 10' Cord, Bronze, 506357

The Little Giant 506357 6-CBA automatic submersible epoxy impregnated cast bronze pump is ideally suited for sump systems where the water is brackish, salty, or briny such as sump systems where treated water flushes into the sump pit or in areas where brackish water is present. The 6-CBA comes equipped with a continuous duty, 1/3 hp 115-volt, shaded pole, oil-filled motor with thermal overload protection. This pump delivers up to 2760 gph (46 gpm) at 5' lift, has a shut-off of 18' and a maximum psi of 7.0. The 6-CBA has a 1-1/2 FNPT discharge. The maximum fluid temperature is 140 °F. The 6-Series is CSA listed in the USA and Canada.Designed specifically for sump systems, the pressure activated integral switch (not adjustable) activates when the water level is between 7" and 10" and shuts off when the water level drops to between 1" and 4". The switch cannot be overridden for manual operation and is therefore not recommended for emergency water removal or general water transfer. This pump comes with a 10' cord. SWITCH OPTION TIPS:- Integral diaphragm switches are designed for sump systems only. Minimum basin diameter required is 10".- Mid-level integral diaphragm switches cycle more frequently. They are designed for shallow under sink or laundry tub systems. Minimum basin diameter required is 10".- Piggyback float switches are designed for sump systems, emergency water removal or water transfer applications. They can be switched to manual mode easily by unplugging the pump from the switch and plugging it directly into the outlet. Float switches require more room to activate the switch, the minimum basin diameter is 18".- Piggyback diaphragm switches are designed for sump systems, emergency water removal or water transfer applications; They can be switched to manual mode easily by unplugging the pump from the switch and plugging it directly into the outlet. The minimum basin diameter is 10".

• AUTOMATIC SUBMERSIBLE PUMP: ideal for sump systems with briny/salty water or for sump systems where water treatment systems empty into the sump pit (switch is not adjustable)
• BUILT TO LAST: Epoxy impregnated cast bronze motor housing; nylon impeller; propylene volute; Nitrile/carbon/ceramic shaft seal; rated for continuous duty
• CONTINUOUS DUTY MOTOR: 1/3 HP shaded pole motor, 9.0 running Amps, 14.3 starting Amps, 720 Watts, thermally protected, CSA listed in the USA and Canada
• BUILT-IN DIAPHRAGM SWITCH: pressure activated non-adjustable switch; on at 7 - 10"; off at 1 - 4"; NOT recommended for emergency water removal or general dewatering
• SPECIFICATIONS: 1/3 hp; 115 Volts; 50/60 Hz; 9.0 running Amps; 14.3 starting Amps; 720 Watts; 2760 gph at 5' lift; 18' shut-off; 7.8 PSI; 10' cord; 1.5" FNPT discharge; 140° max fluid temperature