High Performance Alltrax XCT-48500 Controller Club Car Precedent/IQ 48V Golf Cart Controller (Regen ONLY) 500 Amp 20-22 mph & 30% More Torque Made in USA

Performance Specifications Vehicle Speed : 14 MPH Torque Enhancement : +30 % 1. Torque Focus 2. All wiring throughout the golf cart must be upgraded to a minimum of 4 AWG. We recommend our Wire Upgrade Kit. 3. Must upgrade to a heavy duty Solenoid. We recommend our Solenoid Kit (kit includes solenoid, resistor, diode and mounting brackets). 4. This controller has an extended housing. From end to end, it measures about 10 inches to the end of the Buss Bar. 5. This controller is fully epoxy coated and does not need to be covered. 6. Enhanced thermal characteristics over the standard factory controller and therefore, much less likely to burn up. 7. This is an economical hunting buggy solution. 8. If your application has rolling or very steep hills along with the vehicle having a lift kit, big tires, a backseat or a utility bed, then you will most likely burn up 4 vehicle parts. Those parts include the motor, solenoid, wires and *forward & reverse switch (*series carts only). If the operator does not upgrade those parts to the level that is required, then D&D Motor Systems will not be held responsible for any damages, injuries or death that may occur. Note: *** Vehicle performance specs are compared to the standard factory performance. Several factors can effect the performance. Some are battery conditions; tire size, tread type and air pressure; and varying environmental conditions. Standard factory speeds normally run between 12 - 14 MPH!!! All vehicle speeds noted are calculated on flat ground. Adding Larger tires normally adds between 2-3 MPH. DISCLAIMER - BY PROCURING THIS ELECTRIC MOTOR, THE CUSTOMER AGREES THAT THEY HAVE ANSWERED YES TO ALL OF THE QUESTIONS LISTED ABOVE. OTHERWISE NO PRODUCT LIABILITY CAN BE PROVIDED OR ASSUMED. IF YES IS ANSWERED TO THE ABOVE QUESTIONS, THEN THE APPLICATION IS APPROVED BY D&D.

• XCT-48500 Alltrax Controller – This golf cart controller is for Club Car Precedent/IQ 48V Motors - Regen motors only - free programming cable & solenoid brackets included
• This Alltrax controller is an economical way to gain enhanced torque, thermal capabilities, and speed (Alltrax Controller)
• This Alltrax Controller is usable out of the box (plug and play). It's pre-programmed work with your stock OEM golf cart motor for the Make/Model you have chosen above. Flexible USB or Bluetooth programming is available. (Golf Cart Controller)
• To Confirm this Alltrax Controller model is best for your golf cart setup, call us or go to the D&D Motor Systems website and use the "Choosing A Golf Cart Motor Tool" (Alltrax controller club car)
• No warranty is provided unless we contact you and approve your setup. All Alltrax controllers are MADE IN THE USA (Golf Cart Controller)