EC5 Jump Starter Cable with Battery Clamps for 12V Emergency Portable 10AWG Car Jump Start Battery Booster Cable Replacement Alligator Clips-Booster Jumper Cables -Car Jump Starter Battery Clip (2pcs)

Color: Black redStarting current: 200AInput voltage: 12VStrong alligator clamp clip with EC5 plug connectorUsage of Car Jump Starter:1. Connect the red battery clamp of jumper cable to the vehicle's positive (+) battery and connect the black to the negative pole.2. Plug the cord of the jumper cable into the jumper starter's socket.3. Start the vehicle.Cautions:1. Do not reverse the operation sequence of the jump starter.2. Do not use jump starter to start the vehicle if the number of battery indicators is less than 3 to protect the jump starter from damage.3. Do remove the product from the vehicle within 30 seconds after the vehicle starts, or it may cause security incidents.4. Please be careful when using this product, this item can NOT be overloaded. Please check your device's power before using it.5. Note: Please check your power bank if it can support your car.

• The Battery jumper cable designed to serve as a jump starter replacement cable clamp set for most brands of 12V mini portable jump boxes. Compatible with most car mini jump portable starters, and mobile chargers to jump-start a dead or weak car battery.
• Wire: 10 AWG, OD 5.5mm, Jacket: Silicone Rubber. Connector: EC5 Female Plug. Compatible with most 12V battery booster jumper with EC5 male output.
• EC5 Jump Starter Cable with Battery Clamps - 12V Replacement Alligator Clips to EC5 Connector Car Jumper Cable for Emergency Portable Car Jump Start Battery Booster Cable 10AWG Wire
• The booster jumper cables is used to connect the car emergency starting power supply and car battery, to prevent the power supply positive and negative poles collide or cause a short-circuit situation, high safety factor, after the car is started, the anti-reverse charging current is less than 1A
• 1 - Connect the red battery clamp of the jumper cable to the vehicle's positive (+) battery and connect the black to the negative (-) pole; 2 - Plug the cord of jumper cable into the jumper starter's socket; 3 - Start the car and remove the clamps.