DC 3V-6V bis 400kV 400000V 1000KV Boost Step up Power Module Generator(400kv)

Sensor BlocksDescription:input voltage: DC 3 V to 6 V Input current: 2 A - 5 A High pressure type: the type of pulse current Output voltage: 400000 v(Please pay attention to safety) High pressure discharge distance between: 10 mm - 20 mm The output high voltage wire length: 100 mm Input power cord length: 100 mm (the red line is positive) Wiring: Red and green power connection red line:"+" green line "-" output : the other side ,same color cable Precautions for module use:1. The high-voltage module should avoid power on when the high-voltage is no-load. Before power on, the appropriate distance of the high-voltage line end must be adjusted. The arcing distance of the high-voltage line is proportional to the voltage and capacity used.2. The test of arc distance shall be conducted from short to long, and it is strictly prohibited to exceed the maximum arc distance when power is on, because the high-voltage energy cannot be released, it is very easy to damage the module.3. The power of the module is large, so it is not suitable for internal heat dissipation, so it can not work for a long time. Generally, it is OK within 10 seconds.4. The way to judge whether the capacity can drive the maximum output power is to measure the voltage when arcing. If it is about 6V, it can output the maximum power.5. Two small capacity Li batteries are connected in series at 7.2V. The measured voltage has dropped to about 4V in arcing state. The smaller the capacity, the lower the voltage. Therefore, it is recommended to use a Li with a capacity of more than 2000mA. If possible, it is better to use a with a capacity of more than 4000maPackage includes: 1 x Boost Step-up Power Module High-voltage Generator

• Sensor Blocks