Capacitive Soil Moisture Sensor 3.3V Compatible with Arduino (2-PAC)

Dealing with water or moisture, waterproof is essentially important. The components of the Plantmate Capacitive Soil Moisture Sensor are over-molding, it is waterproof; Plantmate Capacitive Soil Moisture Sensor has the sensor probes on both sides of the PCB, it is more sensitive and accurate;. Plantmate Capacitive Soil Moisture Sensor has a longer cable to connect with your MCU board, cable itself is about 85cm with a Micro USB male end. it comes with a Micro USB female adapter to make it even easier to use. Surely that you can cut off the Micro USB male end to connect with your MCU pins directly.. Plantmate Capacitive Soil Moisture Sensor operates with 3.3V and it is compatible with low-voltage MCUs. To make it compatible with a Raspberry Pi, an ADC converter is required. . Interface : Micro USB. Operating : Voltage3.3 V DC. Output : Voltage3.0 V DC. Cable length : 85 cm. Weight : 32g. Wire Assignments:. Wire Description Red 3.3V DC-input (“VCC” on Micro USB). Gray & White 0-3 V Analog signal output (” D+ & D-” on Micro USB). Black GND (“GND” on Micro USB). Package Content: 2* Plantmate Capacitive Soil Moisture Sensor;. 2* Miro USB adapter;. 2* 4 pin header.

• The components of the sensor are over-molding, it is waterproof.
• Sensor probes on both sides of the PCB, it is more sensitive and accurate.
• it comes with a 150 cm length Micro USB cable and a female adapter to make it even easier to use. Surely that you can cut off the Micro USB male end to contact your Arduino pins directly or extend it to 100 feet.
• This Soil Moisture Sensor operates with 3.3V and it is compatible with low-voltage MCUs. To make it compatible with a Raspberry Pi, an ADC converter is required
• Pin: Analog signal output, GND, VCC
• Applications:Garden plants;Moisture detection;Intelligent agriculture
• Made of a corrosion resistant material giving it a long service life.
• Insert it into soil and impress you with the real-time soil moisture data.