Bob Smith Industries Combo Pack with 1 OZ Medium Viscosity Insta-Cure + TM Cyanoacrylate CA Super Glue and 2 OZ Accelerator Insta-Set TM

Insta-Cure+ is a BSI’s medium or higher viscosity CA glue for loose fitting joints or filling small gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ activator should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.. MAXI-CURE also bonds fiberglass, hardwood, metal and rubber better than any other hobby adhesive. INSTA-SET is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET significantly enhances a joint’s strength. For difficult to bond materials, INSTA-SET can be applied to one surface and CA to the opposite surface. When brought together, they will bond instantly. INSTA-SET is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.

• Set includes 1 ounce bottle of medium viscosity (Insta-Cure + TM) Cyanoacrylate CA Super Glue 2 ounce bottle of Accelerator (Insta-Set TM).
• Insta-Cure+ is a BSI’s medium or higher viscosity CA glue used for loose fitting joints or filling small gaps.
• INSTA-SET (TM) is a catalyst which acts as an accelerator that allows CAs to fully cure in 6-8 seconds. INSTA-SET (TM) is formulated with a strawberry scent and activates CA without any degrading of the CAs strength. UN-CURE (TM) debonder will soften cured CA to clean up squeeze out, spills or for disassembly.
• CA glue comes with fine tip applicator
• 100% made in the USA!!