500W 1000W 1500W Generator Heater 120V 240V Self-circulating Preheater Thermostat Water Heater Jacket Parts(500W,120V)

Generator Water Heaters 120V 240V Self-circulating Engine Preheater heating generator Thermostat water heater pre heating generator jacket heater parts1 .Heater should be intailed vertically and make heater outlet upwards.2 .Heater should be mounted under generator base with bolts.Pipe Installation Instructions1.Pour out cooling liquid clearly2 .Link pipe and fitting in the vacuum side of cooling system correctly and probably in I owe rest position. Then link heater inlet with steel tube of generator by using a 8mm hose and tighten up lathedog.3 .Link heater outlet to pressure side of water pump by more than 160mm outlet pipe. Hose link heater outlet with pipe fitting of generator4 .Don , t link heater outlet pipe to generator until we pour cooling liquid into outlet pipe fully. It aims to release air in the outlet pipe and prevent any freezing of cooling liquid and operation failure. After linking outlet pipe to generator, keep pouring water.Warning:1. Outlet pipe hose should be as straight as possible, and not be flat2. Hoses should not be torisoned or ringed during installation.3. Hose outlet pipe should not be higher than junction of generator.Checking After Installation1 .Check heater and pipes fitting whether they are installed correctly and firmly.2 .Start generator. Check cooling liquid pipe, add water to correct water level and then check wether there is leakness or not. And stop and cool generator.3 .Link heater outlet to pressure side of water pump by more than 160mm outlet pipe. Hose link heater outlet with pipe fitting of generator.4 .You can feel warmth of outlet pipe or hose connecting to generator. Otherwise,switch off heater battery. Then release air and keep heater working.5 .Ater a few mimutes, check whether generator and inlet hose become warm stably and inspect heater automatic working condition-open-close-open.Warning:1. Don't switch on until heater i

• Quickly heats engine block for smoother cold starts and reduced wear.
• Low power consumption with high heating performance, ideal for winter.
• Comes with adhesive backing or magnetic base for quick setup.
• Made with high-temp materials; built-in thermal protection.
• Suitable for most cars, trucks, tractors, and small engines.