4-Ch. Vehicle Audio Bass Amplifier - 300W D Class High-Powered Mono Bass Amp w/Subsonic & Low Pass Filters Stable @ 2 Ohms, LED Indicators, Sound Specialization, Orange - BANDA 1200.42OHMORANGE

Banda 300 Watt 4 Channel 2 Ohm Car Amplifier 1200.42OHMORANGE @ 2 Ohm Car Audio Amplifier. Do not use an impedance load lower than the amplifier specification. This can damage the equipment. Use wire solder for tinning the cable end for better electrical contact. Loose electrical connection can cause malfunction, heating and even fire. The GND connection must be as short as possible, using an adequate wire terminal firmly connected to a clean, paint free spot at the car chassis. It allows you to adjust the Crossover by selector key: LOW, FLAT e HIGH.

• POWER SUPPLY: Class D vehicle audio amp, Total PWR 14.4 @ 2 Ohms: 4x400 WRMS, Total PWR 14.4 @ 4 Ohms: 4x260 WRMS, Total PWR 14.4 Bridged @ 2-4 Ohms: 2x800 WRMS, Total Power 12.6 @ 2 Ohms: 4x300 WRMS, Efficiency @ 4 Ohms: 92% , Efficiency @ 2 Ohms: 80%
• MONO BASS AMPLIFIER INDICATORS: Blue LED: source and powered amplifier indicator, Red LED: output distortion (clipping), Constant - shorting and thermal protection indicator, Yellow LED: below specified voltage indicator (flashing)
• POWER OUTPUT AND IMPEDANCE: Input Voltage: 9 to 15V, Input Impedance: 100K Ohms, THD + Noise: <1%, Input Sensitivity: 160mV to 4V, Signal to Noise Ratio: 86dB
• SOUND SPECIALIZATION: This high-powered Power Amplifier is cutting edge technology at its finest. RCA connectors ensure a secure connection between amplifier and speakers that allow distortion-free sound
• OTHER TECHNICAL SPECS: Recommended Fuse: 80A, Current at Rest: 1.5A, Ave. Current Draw (Sinusoidal): 150A, Ave. Current Draw (Music): 75A, Power Wire Gauge: 16mm/5 AWG, Speaker Wire Gauge: 2x2,5mm/2x14 AWG, Size: 2.2” x 8.4” x 9.7” -inches