25-2430 25MM Planetary Reduction Brushless Electric Gear Motor Engine with High Long Lifetime 18-1411RPM(12V 1411RPM)

Pneumatic MotorsDescriptionMicro-line DC brushless motor DC brushlessCan be forward and reverseMetal gearsSmooth and wear-resistant12V24V optionalWarning: It is forbidden to connect the positive and negative poles of the wrong power supply, the signal line is forbidden to connect the power, and the wrong motor is not guaranteed!Black ---- motor power supply negative (not faultable)Red ---- motor power supply positive (not fault-sensitive)The yellow ---- signal line motor has 12 pulse signals per turnWhite ---- duty cycle, pulse width speed regulation 15-25KHz(When the speed is not regulated, it is started with the black power supply negative pole, and the maximum speed of the power supply runs)The orange ---- forward and reverse lines (with black connecting the negative pole reversal) default overcurrent protection of 0.8A, exceeding 0.8AAutomatic current protection, stall protection, need to be re-energized to start again.Motor considerations1, when you use the motor, there must be no binding things, such as adhesive do not go through the rotating bearing injection bearing, hinder the operation of the motor.2. The rotation of the shaft may have the opposite effect on the life of the motor. For the sake of extended life, please check that your load is in accordance with the regulationsIt is necessary not to overload or hang items that hinder rotation at the end of the shaft.3, manufactured into an eccentric heavy radiation load, harmful to the life of the motor.4. Do not store in the surrounding high temperature or extreme humidity, and do not place in corrosive gas, which will reduce the motor effect.5. The motor should not be run in the surrounding high temperature and humidity.6. When the motor terminal of the positive and negative poles of the power supply is to be soldered, the temperature of the soldering iron is 340 °C± 40 °C, and the heating time is within 3 secondsPlastic deformation, allowing solder points to flow into the motor or break the end of the wire during the work, which will cause the motor to function.7, do not let the motor shaft stuck, when the incoming power, in a short period of time will make the motor overheat, burn its accessories.8. Due to the lack of technology of the staff, when the motor encounters the things mentioned in the instructions, or the superficial judgment is obviously negligent, the quality cannot be guaranteedVolume.9. Supply the prescribed electricity, and be sure that it is within the scope of measurable requirements.10. The installation of pulleys or gears should not be abnormally aggravated when pressing in.11. When installing the motor, the screw is too long, which will cause contact between the motor itself and the rotor, which will affect the characteristics.==========High-concerned chemical : NoneOutput Power : 18.65-37.5(include18.65and37.5)Model Number : 25-2430Continuous Current(A) : 12VConstruction : Permanent MagnetType : Gear MotorProtect Feature : Drip-proofCommutation : BrushlessEfficiency : IE 1

• Pneumatic Motors